Q-Logic 2300 manual Fast!UTIL, Introduction, Configuration Settings, 2.3.1, 2.3.2

￿	2 – QLA2340/2340L
	Fast!UTIL

If you have a selectable boot BIOS and want to boot to an FC hard disk, set the motherboard BIOS parameters to None or Not Installed. The ROM BIOS on the QLA2340/2340L HBA automatically configures the FC peripherals.

Some new system BIOSs support selectable boot, which supersedes the QLA2340/2340L HBA BIOS selectable boot setting. Select the QLA2340/2340L HBA FC hard disk in the system BIOS to boot from an FC hard disk attached to the QLA2340/2340L HBA.

2.3

Fast!UTIL

NOTE: The Fast!UTIL BIOS utility does not run on SunSPARC systems. Refer to section 2.4 for information regarding adapter configuration settings and for installing FCode on a QLA2340/2340L HBA in a SunSPARC system.

2.3.1

Introduction

This appendix provides detailed configuration information for advanced users who want to customize the configuration of the QLA2340/2340L HBA and the connected devices.

The QLA2340/2340L HBA can be configured using Fast!UTIL, QLogic’s BIOS-resident configuration tool. Access Fast!UTIL by pressing CNTRL+Q during the QLA2340/2340L HBA BIOS initialization (it may take a few seconds for the Fast!UTIL Options menu to display). If you have more than one QLA2340/2340L HBA, Fast!UTIL asks you to select the QLA2340/2340L HBA you want to configure. After changing the settings and exiting the utility, Fast!UTIL restarts your system to load the new parameters.

CAUTION! If the configuration settings are incorrect, your QLA2340/2340L HBA may not function properly.

The following sections describe the Fast!UTIL options.

2.3.2

Configuration Settings

The first selection on the Fast!UTIL Options menu is Configuration Settings. These settings configure the FC devices and the QLA2340/2340L HBA to which they are attached.

FC2354601-00 A 2-5