Q-Logic 2300 manual Restore Default Settings, Raw NVRAM Data, Advanced Adapter Settings, 2.3.2.3

￿	2 – QLA2340/2340L
	Fast!UTIL

Some new system BIOSs support selectable boot, which supersedes the Fast!UTIL selectable boot setting. To boot from an FC hard disk attached to the QLA2340/2340L HBA, select the QLA2340/2340L HBA FC hard disk on the system BIOS.

NOTE: This option applies only to hard disks; it does not apply to tape drives and other nondisk devices.

2.3.2.3

Restore Default Settings

The Restore Defaults option from the Configuration Settings menu restores the QLA2340/2340L HBA default settings.

2.3.2.4

Raw NVRAM Data

This option displays the adapter’s NVRAM contents in hexadecimal format. This is a QLogic troubleshooting tool; you cannot modify the data.

2.3.2.5

Advanced Adapter Settings

From the Configuration Settings menu in Fast!UTIL, select Advanced Adapter Settings. The default settings for the QLA2340/2340L HBA are listed in table 2-2and described in the following paragraphs.

Table 2-2. Advanced Adapter Settings

Setting	Options	Default
Execution Throttle	1–256	16
Fast Command Posting	Enabled, Disabled	Disabled
>4GByte Addressing	Enabled, Disabled	Disabled
Luns per Target	0, 8, 16, 32, 64, 128, 256	8
Enable LIP Reset	Yes, No	No
Enable LIP Full Login	Yes, No	Yes
Enable Target Reset	Yes, No	Yes
Login Retry Count	0–255	8
Port Down Retry Count	0–255	30
Drivers Load RISC Code	Enabled, Disabled	Enabled
Enable Database Updates	Yes, No	No

FC2354601-00 A 2-7