Q-Logic 2300 manual Setting the QLA2342/2342L HBA Loop ID, 3.4.3, 3.4.4

3 – QLA2342/2342L	￿
FCode

3.4.3

Setting the QLA2342/2342L HBA Loop ID

When the QLA2342/2342L HBA is currently operating in loop mode (through connection mode 0 or connection mode 2), perform the following steps to view its loop ID and change it if necessary:

1.Select the QLA2342/2342L HBA attached to the Fibre Channel device from which you want to boot. For example, type the following at the ok prompt:

ok " /pci@1f,0/pci@1/QLGC,qla@4" select-dev

2.To view the loop ID, type the show-adapter-loopidcommand. ok show-adapter-loopid

The loop ID displays. For example:

Adapter loopid - 7c

3.If the loop ID is not correct, change it using the set-adapter-loopidcommand. For example:

ok 0 set-adapter-loopid

The new loop ID displays. For example:

Adapter loopid - 0

3.4.4

Setting and Viewing the Fibre Channel Data Rate

Use the show-data-rate command to view the current QLA2342/2342L Fibre Channel data rate. For example:

1.Select the QLA2342/2342L HBA attached to the Fibre Channel device from which you want to boot. For example, type the following at the ok prompt:

ok " /pci@1f,0/pci@1/QLGC,qla@4" select-dev

2. Type the following:

ok show-data-rate

3. The current data rate displays. For example:

Current HBA data rate: One Gigabit rate

3-14 FC2354601-00 A