Q-Logic 2300 Installing the NetWare Driver, Select Configure disk and storage device drivers

8 – NetWare Driver Installation	￿
Installing the NetWare Driver

8.3

Installing the NetWare Driver

NOTE: The QL2300.HAM driver may not be compatible with NetWare versions earlier than 4.2.

Perform the following steps to install the NetWare driver in a previously installed NetWare 4.2, 5.x, or 6.x system.

NOTE: The following procedure modifies your NetWare STARTUP.NCF file to load the driver automatically when your system boots.

1.Start NetWare and load the NetWare Install program from the NetWare server prompt (SERVERNAME:).

Type the following command when you are using NetWare 4.2:

LOAD INSTALL

Type the following command when you are using NetWare 5.x or 6.x:

LOAD NWCONFIG

2.Select Driver options from the main menu.

3.Select Configure disk and storage device drivers.

4.Select Select an additional driver.

5.Press INSERT to install an unlisted driver.

6.Insert the disk that contains the QLogic driver in an appropriate drive.

7.Press F3 and specify the root path as the disk drive (A:\).

8.Press ENTER to select the QL2300.HAM driver.

9.If prompted, select Yes to copy the driver.

10.You are prompted for the server directory. Type the path of the server directory, or press ENTER to accept the default.

11.If necessary, select Select/Modify Driver Parameters to modify the default settings.

You can select a different PCI slot or select to not scan all LUNs. Press F10 to save the parameter settings.

12.Select Save parameters and load driver to complete the NetWare setup.

13.When finished, exit the installation program.

NOTE: If ASPI support is required for the SCSI devices, you must load the NWASPI.CDM module, which is provided by Novell. For example:

LOAD QL2300.HAM

LOAD NWASPI.CDM

8-2 FC2354601-00 A