Quadra-Fire QV36DC-A Installing Trim, Refractory, Logs, and Ember Material, Installing the Trim

Step 10. Installing Trim, Refractory, Logs,

and Ember Material

Installing the Trim

Combustible materials may be brought up to the specified clearances on the side and top front edges of the fireplace, but MUST NEVER overlap onto the front face. The joints between the finished wall and the fireplace top and sides can only be sealed with a 300° F. (149° C) minimum sealant.

!WARNING: WHEN FINISHING THE FIREPLACE, NEVER OBSTRUCT OR MODIFY THE AIR IN- LET/OUTLET GRILLES IN ANY MANNER.

Install optional marble and brass trim surround kits as desired. Marble, brass, brick, tile, or other non-combustible materials can be used to cover up the gap between the sheet rock and the fireplace.

Do not obstruct or modify the air inlet/outlet grilles. When overlapping on both sides, leave enough space so that the bottom grille can be lowered and the trim door removed.

Refractory Kit Placement (BRICK-292)

Figure 39.

Figure 40.

CAUTION: REFRACTORY IS FRAGILE! CAREFULLY

REMOVE THE REFRACTORY FROM THE PACKAG-

ING.

Remove the logs and log grate from the fireplace. Place the back wall refractory centered against the back of the fireplace on the back refractory ledge (see Figure 38).

Figure 39.

Position the right wall all the way to back wall. Secure in po- sition same as was done for the left wall (see Figure 42).

Figure 38.

When positioning the left wall use care in not knocking the back wall down. Position the left wall all the way back against the back wall. Using the retaining clip and screw included, secure the side wall refractory as shown (see Figures 39 and 40).

Figure 42.

Quadra-Fire • QV36DC-A • 2161-900 Rev. C • 6/09 31