11.5 Quad Display | Chapter 11 |
4:The setup menu can be reset to factory setting by pushing the Setup buttons (#1, #2) and power on the quad simultaneously. The factory setting is as follows:
CH | TITLE | DWELL TIME |
| QUAD | 03S |
1 | CH 1 | 03 S |
2 | CH 2 | 03 S |
3 | CH 3 | 03 S |
4 | CH 4 | 03 S |
LIVE VIDEO FREEZE |
| ON |
VIDEO OUT: | LIVE | QUAD |
TITLE: | ON | ON |
TIME: 23 : 10 : 10 | ON | ON |
DATE: 12 - 25 - 2003 | ON | ON |
| ALARM SETTING |
| |
CH | SENSOR | TYPE | STATUS |
1 | OPEN | NO | ON |
2 | OPEN | NO | ON |
3 | OPEN | NO | ON |
4 | OPEN | NO | ON |
SENSITIVITY: |
| 0.3 S | |
DURATION: |
| 30 S | |
BUZZER: |
|
| ON |
| ON | ||
| OFF | ||
|
|
|
|
5.The Quad Display Mode
5.1Push Quad display button (#4) to switch between Quad screen and Full screen display mode. Right after you turn on the system, the unit is in the quad mode and displays cameras
5.2Use page 1 of the Setup menu to turn the Title display ON/OFF on each channel and also enable and disable the Time and Date display on LIVE and QUAD output channels.
5.3Under Quad screen mode, push channel select button to freeze each camera input.
6.The Full Screen Display Mode
6.1Push Quad button (#4) to OFF to enter Full screen display mode. Under this mode, you may call up any spe cific channel in full screen by simply pushing the corresponding channel selection button.
6.2Push the Quad button (#4) to ON to return to the quad mode.
7.The Still Frame Display Mode
7.1If the still screen mode is desired, first turn the quad display button (#4) to ON to set the unit to display in the quad mode. At this time you may press any of the four channel selection buttons (#5) to freeze the corresponding channel.
7.2Under Zoom On VCR playback mode, if the unit is showing quad screen, pushing the channel selection but tons (#5) will call up the specific channel to display in full screen. Push the same channel selection button again to freeze that channel in full screen.
8.The Auto-Sequence Mode
Push the Sequence button (#3) to ON to set the device to work as a sequencer. Under this mode, the display sequence first starts with a quad screen and then continues to display each camera input in full screen, and then gets back to quad screen and so on. Press the Sequence button (#3) to OFF to release this mode.
P.39
