566+06*&+#.+0/1, Setting the Dialing Mode

display. The handset charged in the cradle must also be registered with the base prior to use.

Place the second handset on the base. The base’s CHARGE LED flashes. When the registration is complete >I( appears in the second handset’s display.±

5'66+0)"6*'"&+#.+0)"/1&'

Your phone comes set for tone dialing. If you have pulse service, you need to change the dialing mode.

If you are not sure which type of service you have, do this test:

1.Lift the handset, press TALK/FLASH, and listen for a dial tone.

2.Press any number other than 0 or, if required, an outside line access code (9, for example).

If the dial tone stops, you have touch-tone service.

If the dial tone continues, you have pulse service.

Once you have determined which type of service you have, set the dialing mode. Use handset HS1 to set the dialing mode.±

1.Press END to hang up the phone if necessary, then hold down CID/MENU until the selection screen appears.

2.Press 4 or 9three times to select :_Wb.

3.Press CH/SEL to toggle between Jed[ýand Fkbi[.

±ý

4.To store the new setting, press END, and return the handset to the base.

±"016'"±"

•Once registered, you may charge HS1 and HS2 on either the base or the charging cradle.

•When a power failure occurs, or the base unit’s power is disconnected for longer than one hour, both handsets will need to be re-registered.

•You cannot use HS2 to set the dialing mode. Check the handsets’ displays to distinguish between HS1 and HS2.

•The phone exits setting mode if a call or page is received, or if you press END.

Installation