Radio Shack 43-3820 owner manual 100%6+0.%*#4+0#0& 42.#%+06*$#6642#%, AndýBemý8Wjjho

%100'%6+0)."%*#4)+0)"#0&" 4'2.#%+0)"6*'"$#66'4;"2#%-

The phone comes with a rechargeable Ni-Cd (nickel-cadmium) battery pack installed in each handset, but not connected. Before using your phone, you must connect the battery packs, then charge them for about 24 hours.

1.Press down and slide off the battery pack compartment cover.

2.Lift the battery pack out of the compartment.

3.Plug the battery pack’s connector into the

socket in the compartment. The connector fits only one way.

4. Put the battery pack in the compartment.

5. Replace the cover.

To charge the battery packs, place one handset on the base, face up or down. The base’s CHARGE LED lights. Place the other handset on the charging cradle. The cradle’s CHARGE LED lights#"

Recharge the battery pack when Bemý8Wjj[hoý flashes.±ý

When you first use the phone after charging or recharging the battery packs, the phone might not work and you might hear error beeps. If this happens, return the handset to the base for about 5 seconds to reset the security access-protection code.

Using a pencil eraser, clean the charging contacts on the handset, the base, and the charger about once a month.

#"+/2146#06"#

Be sure the battery pack is properly connected before you try to charge it. The CHARGE LED lights when the handset is on the base or cradle even if the battery pack is not connected properly.

±"016'"±"

•If the phone does not work, recharge the battery pack. (The battery power might be too low for the display to operate.)

•If the battery pack becomes weak during a

call, the handset beeps

andýBemý8Wjj[ho

flashes. When this happens, you cannot make a call on the phone until you recharge the battery pack.

•If the battery pack is completely discharged or the base loses power while the handset is away from it, place the handset on the base to reset the security access-protection code. If it was the handset that lost power, recharge the battery pack.

Installation

9