Trunking Operations AFS Format | Radio Shack PRO-433 specs

Trunking Operations

AFS Format

Your scanner can translate decimal talk group lists to the much more powerful AFS format. Become familiar with AFS partial entry, and your scanning will become more ﬂexible and efﬁcient.

The AFS format allows you to enter full or partial EDACS IDs for powerful ﬂexibility in all modes.

1. Select the trunking programming mode and a bank.

2. Press or to select EDACS, then press E/PGM.

3. Press or to select AFS, then press E/PGM.

4. Press or to select AFS ON or AFS OFF, then press E/PGM.

talk group ID search range (EDACS)

You can program a speciﬁc talk group such as 01-011 into the scan list memory. In AFS mode, you can program the talk groups for an entire agency by pressing corresponding keys.

You can set a range for agencies or ﬂeet listings for the scanner’s EDACS talk group ID search.

To set a search range, complete the following steps:

1. Press HOLD.

2. Use the number keys to enter the agency number. For example, “01.”

3. (Optional) To search within a speciﬁc ﬂeet, see the number keys to enter the agency number. For example, “01.”

For example:

You Press	To Scan
01.E	all 01 groups
01.01E	all 01 talk groups within the 01 agency
4. Press SRCH.

28

Image 28

Radio Shack PRO-433 quick start Trunking Operations AFS Format, Talk group ID search range Edacs

Contents

PRO-433 1,000 ch Trunking Desktop/Mobile Scanner Quick Start Contents Quick start BasicsBeyond the basics Trunking operations Special features ContentsCare Installing your scanner Quick startBase station Vehicle mounting When mounting in your dashboard, you will need to Power your scannerWall outlet Vehicle cigarette lighter or power port If you are not experienced in connecting accessories toVehicle fuse box, use a certiﬁed installer Connect your scanner Connecting an external speaker mutes the scanner’s AntennaExternal speaker Internal speaker Quick Start Setting up your scanner Turning on your scannerStoring frequencies in channels Copying / moving frequencies Searching for frequencies Earphones / headphones Quick Start Monitoring and scanningMonitoring Scanning Basics Basics Your scanner’s controls Trunk Your scanner’s display PGM Scan Replacing the fuse Appears when you activate the priority feature Beyond the basicsChannel-storage banks Priority channels Banks, the error tone beeps At least one bank must be active. If you disable allBeyond the Basics Chain search It can take several minutes to search all the service Service bank searchWeather search and alert Fips codes Beyond the Basics Skywarn Beyond the Basics Signal Stalker Turn off the data skip feature if it is on Data skip Delay Using the memory lock does not prevent the scanner fromKeytones Memory lock Trunking operations Programming trunked frequencies Talk group ID Storing talk group IDs Scanning a talk group ID list Locking out a talk group IDOne of the ten scan lists must always be active. You Cannot remove all of them Monitoring a talk group ID Priority talk group ID scanningLocked out Trunking Operations AFS Format Talk group ID search range Edacs You cannot use partial talk groups in decimal mode Status Bit S-Bit Ignore Trunking Operations Trunk search and scan Type I and hybrid trunked systems Preset ﬂeet maps Programming a ﬂeet map For Motorolla Type II, instead of selecting the size block Programming base and offset frequenciesEnter size code S-0 Motorola disconnect tone detect function Special features Seconds, T-Err appears and wired programming stopsPC programming Scanner cloning Special Features Troubleshooting Care Resetting the scanner Service and repairTo ensure that the scanner clears its memory properly Leave it on until CLEAr stops ﬂashing Speciﬁcations Speciﬁcations UBZZ01345ZA0