Radio Shack PRO-433 quick start Programming base and offset frequencies, Enter size code S-0

Trunking Operations

codes S-12, S-13, or S-14, these restrictions apply:

•S-12 can only be assigned to Blocks 0, 2, 4, or 6

•S-13 can only be assigned to Blocks 0 and 4

•S-14 can only be assigned to Block 0

Because these size codes require multiple blocks, the NOTE scanner prompts you for the next available block when

you program a fleet map. For example, if you set Block 0 as S-12, b2 is the next block instead of b1. If you assign Block 0 as S-14, you would not see another prompt because S-14 uses all available blocks.

6. Selecte a size code for each desired block.

NOTE	For Motorolla Type II, instead of selecting the size block,
	enter size code S-0.

7. Press SRCH. The scanner searches using the map you programmed.

programming base and offset frequencies

To properly track Motorola VHF and UHF trunked systems, you must program the applicable base and offset frequencies for each system.

1. Select the trunking programming mode.

2. Press the number key of the bank where you want to store the base frequency.

3. Press or to select Motorola Type II UHF or VHF system, then press E/PGM.

4. Press or to select bASE, then press E/PGM.

5. Press the configuration Block Number (1-3) .

6. Press the number keys to enter a new base frequency, then press E/PGM.

7. Press . The display changes to spacing-frequency entry mode.

33