RCA CC643 manual Playback Operation, Viewing What the Camcorder Is Recording, Normal Viewing

Playback Operation

1.Set the CH3/CH4 switch on the RF output adapter to channel 3 or 4.

2.Turn on the TV, and tune it to the same channel you selected with the RF output adapter's CH3/CH4 switch.

3.Place adapter's VCR/TV switch in VCR.

4.Place POWER switch in VCR. Power indicator will light.

5.Press PLAY/PA USE on the camcorder.

•During playback, use the playback features described on pages 59-61.

6.Press STOP on the camcorder when you are finished.

Viewing What the Camcorder Is Recording .......,,_

1. Turn on the TV and tune it to channel

3 or 4. When the camcorder is used as

a camera, turn the TV's volume down

to prevent a high-pitched squeal caused by feedback.

2.Set the CH3/CH4 switch on the RF output adapter to the same channel you selected on the TV.

3.Place adapter's VCR/TV switch in VCR.

4.Place POWER switch in CAMERA. Power indicator will light.

5.Press the thumb trigger to begin

recording. You can watch what the

camcorder is seeing (or recording) on the TV screen.

Normal	TV	Viewing	_	__"_,_		o	:__o_,_
For normal TV viewing, you			may leave	the camcorder	and place	the adapter's
the RF	output	adapter hooked	up to the	VCR/TV switch	in TV..

TV. Disconnect the adapter's plug from

Note to Cable TV Installer

This reminder is provided to call your attention to Article 820-40 of the National Electrical Code (Section 54 of Canadian Electrical Code, Part I), that

provides guidelines for proper grounding and. in particular, specifies that the

cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.

65