RCA HDLP50 manual Digital or Analog TV Channels, Direct Tuning to a Channel

Using the TV’s Features

Digital or Analog TV Channels

A single off-air antenna can pick up both analog and digital channels. Digital channels can be made up of primary channels and subchannels.

Note: Subchannels (sometimes called minor channels) are channels associated with the primary channel (sometimes called the major channel). A primary channel may have just one subchannel or multiple subchannels.

		A “D” is displayed for digital;				Tip:
		an “A” is displayed for analog
						Use the channel banner to determine whether
						a channel is digital or analog. A digital (ATSC
			D	6-1 DNLJ
						or QAM) channel displays a “D” before the
						channel and may have a dash and second
		Primary			Subchannel	number after it (e.g., 21-1); an analog channel
						(NTSC) displays an “A” before the channel and
		Channel			(if necessary)	only has one channel number (e.g., Ch 21).
D	6-1 DNLJ						Cable Input
English						16x9 Normal 1080i HDTV
		MPAA - Not Rated					12:00 PM - 1:00 PM

Direct Tuning to a Channel

1.Make sure the remote is in TV mode by pressing TV on the remote control.

2.Enter the primary channel number. This number appears in the primary channel entry box. Press OK or wait a few seconds. If you don’t enter a subchannel, the TV tunes to the lowest digital subchannel.

3.If the primary channel number has fewer than six digits (for cable), or two digits (for antenna) and you want to enter subchannel numbers, press the SUB CH or SUBCHANNEL button to advance to the subchannel entry box.

4.Enter the number of the subchannel. This number appears in the subchannel entry box.

5.Press OK to tune to the channel or wait a few seconds and the TV tunes to the channel.

Notes: You can always use the channel up and down buttons on the remote control to change channels within the TV mode.

If you wait too long before entering the subchannel, the TV tunes to the lowest digital subchannel.

Getting a Program Description

1.Make sure the remote is in TV mode by pressing TV on the remote control.

2.Press the INFO button on the remote twice. If the information is available from the broadcaster, a program description will appear.

Chapter 3 39