Chapter 1: Connections & Setup

Things to Consider Before You Connect

Protect Against Power Surges

Connect all components before you plug any of their power cords into the wall outlet or power strip. NEVER plug your TV into an outlet that is controlled by a wall switch.

Turn off the TV and/or component(s) before you connect or disconnect any cables.

Make sure all antennas and cables are properly grounded. Refer to the Important Safeguards sheet packed with your TV.

Protect Components from Overheating

Don’t block ventilation holes on any of the components. Arrange the components so that air can circulate freely.

Don’t stack components.

If you place components in a stand, make sure you allow adequate ventilation.

If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won’t flow around other components.

Important Stand and Base Safety Information

If a stand or base is used ensure that is of adequate size and strength to prevent the TV from being accidentally tipped over, pushed off, or pulled off. This could cause personal injury and/or damage the TV. Refer to the Important Safety Instructions packed separately.

Position Cables Properly to Avoid Audio Interference

Insert each cable firmly into the designated jack.

Use Indirect Light

Don’t place the TV where sunlight or room lighting will be directed toward the screen. Use soft or indirect lighting.

Connection Illustrations

The components used in the connection illustrations are for representation only. The input jacks and the output jacks on the back of your components (VCR, DVD player, etc.,) might look different than those illustrated.

Check Supplied Parts

Check that the following parts were packed with your product.

DVD

ON OFF

VCR TV

VOL

 

CH

MUTE

GO BACK

 

CLEAR

 

MENU

 

OK

 

PRESETS

 

SKIP

CC

 

INFO

GUIDE

 

1

2

3

4

5

6

7

8

9

INPUT

0

ANTENNA

REVERSE

PLAY

FORWARD

RECORD

STOP

PAUSE

AGAIN

ZOOM

OPEN CLOSE

 

 

 

 

 

 

 

SPEED SEARCH

Remote Control

2 AAA batteries

15 pin D-sub to component video cable adapter (use with the RGB/YPbPr jack)

3.5mm mini phone

 

to audio cable adapter

 

(use with the Audio In or

Power cord

Audio Out jack, not the

 

headphone jack)

 

AC Power adapter

Chapter 1

Graphics contained within this publication are for representation only.

3

Page 7
Image 7
RCA LCDS2022B manual Connections & Setup, Things to Consider Before You Connect