Using the Remote Control
Clearing a Learned Function
To delete a learned button function, use the procedure below.
1.Press and hold the component button (the component button lights). Then press and hold the CLEAR button for 3 seconds (the component mode button
2.Release the component and CLEAR buttons (the component button being cleared turns on). Remote is now in Clear learned function mode.
3.Press and release the button where learning is to be cleared. The component button blinks off then back
4.Repeat steps 1 through 3 until all buttons’ learned functions have been cleared.
Note: If an invalid button is pressed, the component mode button(s) flashes 4 times and the selected component button stays on and remote remains in Clear Learned Function mode. Repeat step 3.
5.Press the CLEAR button to return the TV remote to its original operation mode.
Deleting ALL Learned Functions
This procedure erases all learned functions in every component mode of the remote.
1.Press and hold the CLEAR button (the current component button lights). Then press and hold the ON•OFF button (component button light turns off for 3 seconds, flashes, turns on and off) while continuing to hold CLEAR.
2.Release both buttons (current component button turns on).
3.Press any component button to delete all learned functions in all modes. Remote is automatically exited from this mode.
Note: Pressing the CLEAR button will NOT delete all learned functions, but will exit the Delete mode.
Volume Punchthrough Feature
You may find this feature helpful if you’ve connected your components to an audio/video receiver (A/V receiver) or amplifier, but you want to use the TV’s remote control to operate the volume for a component that is connected to the audio/video receiver. An example follows:
Let’s say you’ve connected your DVD player to your audio/video receiver. You’ve also programmed your TV remote control to operate your DVD player. Since the DVD player gets its volume through the audio/ video receiver, you would have to bounce back and forth between two remote controls: the A/V receiver’s remote to adjust the volume and the TV’s remote control to operate the DVD player.
The Volume Punchthrough feature eliminates the need for you to use two remote controls and saves a button press when you’re using the TV remote to adjust the volume. In effect, you are telling the TV remote to retrieve and send volume commands from the A/V receiver whenever the TV remote is in DVD mode.
Therefore, after you’ve successfully set up the Volume Punchthrough feature, whenever the TV remote is in DVD mode (press the DVD button) and you want to adjust the volume, you only have to press the VOL + or VOL- buttons. Follow the instructions below to set up Volume Punchthrough.
1.IMPORTANT: First, you must program the AUDIO button on the TV’s remote control to operate your audio receiver or amplifier. Go to page 12 for instructions. If you can’t program this remote to operate your audio receiver, Volume Punchthrough won’t work.
2.While setting up Volume Punchthrough, it’s best to point the remote away from components.
3.Decide which mode the remote will be in when the volume from the audio receiver “punches through.” The mode will be one of the component buttons (TV, DVD, SAT/CAB, VCR, or AUX/HD).
Chapter 2 | Graphics contained within this publication are for representation only. | 15 |