Connections & Setup
Connection to a Personal Computer
Using RGB
Connect a personal computer to the TV using the RGB jack. Connect a
Note: Your computer will most likely output the signal in a 4:3 aspect ratio. Be sure to change the monitor setting for the best picture quality.
AUDIO
IN
RGB
SUBWOOFER R AUDIO L
OUT OUT
AUDIO OUTPUT
Plug in the TV
Plug the flat end of the cable into the power jack on the bottom panel of the TV. Plug the end of the power cord into an appropriate wall outlet. Be sure to insert the plug completely. Do not plug into an outlet controlled by a light switch.
Put batteries in the remote
•Remove the battery compartment cover from the back of the remote by pushing down on the tab and lifting the cover.
•Insert 2 fresh “AA” batteries. Make sure the polarities (+ and
•Replace the cover.
Turn on the TV
Press TV on the remote, or press POWER on the TV’s side panel.
Note: Pressing the TV button turns on the TV and puts the remote into TV mode. “TV mode” means that the buttons on the remote control operate the TV’s functions.
Adjust the Viewing Angle of the TV
The TV’s screen is adjustable simply by pushing on the top, front part of the screen, while your other hand holds the base of the TV.
Set Up Your TV
There are several options you might need to set up in order for your TV to work properly. Turn on your TV, then press the MENU button on your remote control. Read the instructions that follow.
8 | Graphics contained within this publication are for representation only. | Chapter 1 |
