Chapter 1: Connections & Setup
Things to Consider Before You Connect
Protect Against Power Surges
•Connect all components before you plug any of their power cords into the wall outlet or power strip. NEVER plug your TV into an outlet that is controlled by a wall switch.
•Turn off the TV and/or component(s) before you connect or disconnect any cables.
•Make sure all antennas and cables are properly grounded. Refer to the Important Safeguards Instructions at the beginning of the manual.
Protect Components from Overheating
•Don’t block ventilation holes on any of the components. Arrange the components so that air can circulate freely.
•Don’t stack components.
•If you place components in a stand, make sure you allow adequate ventilation.
•If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won’t flow around other components.
Important Stand and Base Safety Information
If a stand or base is used ensure that is of adequate size and strength to prevent the TV from being accidentally tipped over, pushed off, or pulled off. This could cause personal injury and/or damage the TV. Refer to the Important Safety Instructions at the beginning of the manual.
Position Cables Properly to Avoid Audio Interference
Insert each cable firmly into the designated jack.
Use Indirect Light
Don’t place the TV where sunlight or room lighting will be directed toward the screen. Use soft or indirect lighting.
Connection Illustrations
The components used in the connection illustrations are for representation only. The input jacks and the output jacks on the back of your components (VCR, DVD player, etc.,) might look different than those illustrated.
Check Supplied Parts
Check that the following parts were packed with your product.
learning
TV
DVD 
VCR
SAT/CAB AUX/HD AUDIO
PIP SWAP PIP+ SLEEP
ZZZ
FREEZE ZOOM PIP- LIGHT
DISC MENU | INFO |
i
CLEARMENU
cM
ZOOM- | OK | ZOOM+ |
PRESETSSKIP
GUIDE
VOLCH
MUTE GO
BACK
1 2 3
4 5 6
7 8 9
INPUTANTENNA
0
3.5mm mini phone
2 AA batteries | to audio cable adapter |
| |
| (use with the RGB Audio |
| Power cord |
| In jack, not the |
| headphone jack) |
REVERSE PLAY FORWARD
RECORD STOP PAUSE
Remote Control
Chapter 1 | Graphics contained within this publication are for representation only. | 3 |
