RCA P46732, P52731 Adding Video Input Channels to Channel Memory, An active channel may be missed

ThechannelmemoryisthelistofTV channelnumbersyourTV will stop onwhenyoupresstheCHAN up or

1. AutoProgramming Channels into Channel Memory

--(withor without remote)

down button. You can program any list of channels into the channel memory.

The quickest way to program your channel memory is to use the

A UTOPROGRAM function. If you use the A UTOPROGRAM function,

your TV will automatically cycle through all Channels and place ac.tive channels into the channel memory.

First follow the instructions to

autoprogmm channels, and then add or erase individual channels as desired.

Notes:

lo Connect home antenna(s) or cable- TV to your set.

. After you have turned on the TV and adjusted the volume, repeatedly press MENU.PROG to select SETUP MENU, and then press + or - to display the setup functions.

Repeatedly press MENUopROG to select the A UTOPROGRAM

function.

3.Press either + or - to begin autoprogramming. The TV will first program all channels for ANTA input and then program all channels for ANT B input (even iFyou only have one antenna input connected).

4.When the TV is finished cycling, you can checkto see which channels are in memory by pressing the CHAN up or down button.

• The AutoProgram feature will place into

memory active TV channels that have a

valid signal at the time you autopmgram

your "IV.

2. Erasing/Adding Channels in Channel Memory -- (with or without remote)

• An active channel may be missed

occasionally if its signal is very weak or if

the channel happens to be "off the air"

when the TV is autoprogrammed.

• An inactive channel may be included in the

channel memory if there happens to be

some sort of "noise" or "stray signal" on

the channel when the "IV is

autoprogrammed.

• Signals from other components connected

to the INPUT jacks can not be

autoprogrammed. Channel 91 (which

accesses INPUT 1 jacks) was added to the

channel memory at the factory and will

remain in the channel memory until you

erase it. Channel 92 (INPUT2) and

Channel 90 (S-VIDEO connector) can be

added to channel memory if desired.

• Only channels 1-99 can be stored in

channel memory.

1.To erase or add a channel, repeatedly press MENU.PROG to select SETUP MENU, and then press + or - to display the setup functions. Repeatedly press MENU.PROG to select CHAN MEM function.

2.Then select the desired channel number by pressing CHAN up or down (or the two corresponding number buttons on the remote).

3.Press+ to addthe channel to memory, or press - to erase the channel from memory.

3.Adding Video Input Channels to Channel Memory

-- (with remote)

If you have a video device connected to the S-VIDEOor INPUT jacks on the back of the TV, you can view its signal either by directly selecting channel 90 (for S-VIDEOconnector), channel 91 (for INPUT 1 jacks), or channel 92 (for INPUT2 jacks) with the number buttons on the remote or by adding those channels to the channel memory.

Adding channels 90, 91, and 92 to channel memory allows access to the video inputs at the TV by pressing the CHAN up and down buttons as well as by using the remote control.

24