RCA P46732, P52731, P46738, P52730, P46731 manual Cantselectcertainchannel Noisystereoreception

Can'tselectcertainchannel

Noisystereoreception

No picture, no sound but power light is on

Sound okay, picture poor

Picture okay, sound poor

No stereo on known stereo Station

Can't get two channels in Pix-in-Pix

No picture while Using Pix-in-Pix, with S-VHS VCR or camcorder

Small picture does not have color.

Remote no longer controls cable box, VCR or audio equipment

•Channel may not be in Channel Memory. Try pressing number buttons.

•If using VCR, check to make sure TV/VCR switch on VCR is in correct position.

•To select cable channels 100 thru 128, press number button 1 until 1-- appears. Then press other two number buttons. CABLE/AIR function must be in CABLE mode to select channels higher than 69.

•Channel may be locked-out with Parental Control feature,

•May be a weak station. Change STEREO/SAP function to MONO setting instead of STEREO.

•Maybe someone changed CABLE/AIR function to wrong position.

•Maybe a vacant channel is tuned.

•For Channels 90,91, and 92, make sure the component connected to those INPUT jacks is turned on in order to see the picture.

•If watching VCR (connected only through antenna input), make sure TV is tuned to channel 3 or 4--same as CH3/CH4 switch on VCR. Also check to

make sure TV/VCR switch on VCR is in correct position.

i

! • Check antenna connections.

I • Try adjusting SHARPNESS function to improve weak signals.

* Try another channel.

•Try adjusting VOLUME, BASS, and TREBLE controls.

•If station is sending stereo, try changing STEREO/SAP function to MONO setting for clearer sound.

Try adjusting SRS (O) controls to turn SRS (O) off or on.

•Make sure STEREO/SAP function is in STEREO mode.

•If using the VCR1 or VCR2*LD button, make sure it is programmed to select the proper video input channel as described on page 26.

If Using an S-VHS component, make sure its regular VIDEO cable is connected to INPUT 1 VIDEO jack on the TV.

If usrag a VCR, make sure the AUDIO and VIDEO OUT jacks on the VCR are connected to the TV's AUDIO and VIDEO IN jacks.

If you have an S-VHS VCR (or camcorder) connected, you must also connect a cable from the VCR's VIDEO OUT jack to the TV's corresponding VIDEO IN jack in addition to the S-VHS cable.

The small picture will not have color if the large picture signal does not have

the color burst reference. All color signals and some black-and-white signals

are sent with color burst information. Try changing channels of the large picture.

•Try not to press any buttons on the remote while changing its batteries. You may have to reprogram the proper code into the remote.

49