Regency C34-NG2, C34-LP2 installation manual Installation, Exterior Vent Terminal Locations

10

Regency CLASSIC C34-2 Direct Vent Freestanding Gas Heater

A= Clearance above grade, veranda, porch, deck, or balcony	H= *Not to be installed above a meter/regulator assembly within 36"
[*12" (30 cm) min.]	(90 cm) horizontally from the centre-line of the regulator.
B= Clearance to window or door that may be opened [*12" (30cm)]	J= clearance to service regulator vent outlet [*min. 36" (90cm)]
C= Clearance to permanently closed window min. 12" (30 cm)	K= clearance to non-mechanical air supply inlet to building or
D= Vertical clearance to ventilated soffit located above the terminal within a horizontal	the combustion air inlet to any other appliance [*12 inches]
distance of 24" (60 cm) from the centre-line of the terminal [18" (46 cm) min.]	L= clearance to a mechanical air supply inlet [*min. 72" (1.8 m)
E= Clearance to unventilated soffit [12" (30 cm) min.]	M= **clearance above paved side-walk or a paved driveway
F= Clearance to outside corner: with AstroCap Termination Cap (min 6"/15cm), with	located on public property [*84" (2.1 m) min.]
Dura-Vent Termination Cap (12"/30cm)	N=clearance under veranda, porch,, deck, or balcony [*12"
G= Clearance to inside corner: withAstroCapTermination Cap (min 6"/15cm), with Dura-	(30 cm) min.***]
Vent Termination Cap (12"/30cm)

*As specified in CGA B149 or ANZI 223.1 Installation Codes. Note: local Codes or Regulations may require different clearances.

**A vent shall not terminate directly above a side-walk or paved driveway which is located between two single family dwellings and serves both dwellings

***Only permitted if veranda, porch, deck or balcony, is fully open on a minimum of 2 sides beneath the floor.

EXTERIOR VENT TERMINAL LOCATIONS

INSTALLATION