INSTALLATION
Conversion Kit for NG to LPG Model #736-969
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !!
Conversion Kit
Qty. Part # Description
1
1
2
1
1
1)Shut off the gas supply and unplug the power cord.
2)Open the front door and carefully remove the logs and lava rock.
3)Remove burner.
4)Remove burner orifice with a 1/2" wrench and discard. Use a wrench to hold on to the elbow behind the orifice.
5)Reinstall new burner orifice LPG stamped #50 and tighten.
Burner Orifice
6)Remove the 2 screws which hold the pilot.
7)Lift the pilot assembly and remove the pilot tube using an 11mm wrench.
Antenna
Control Box
Cover
17) Remove the jumper using a plier.
Pilot | Pilot | Pilot |
Orifice | Extrusion | Assembly |
| Tube |
|
8)Remove the NG orifice and replace it with the LPG orifice.
9) | Install the pilot tube to the pilot assembly. | Jumper Location |
|
10)Place the pilot assembly over the pilot extru- sion tube and secure it with 2 screws.
11) Adjust the burner areation setting to fully open and install the burner.
Jumper
12)Remove the pedestal back cover by remov- ing the 4 Philips screws.
Pilot Tube
13)Stick the conversion label "This unit has been converted to LPG" over top of the serial number decal.
14)Replace the yellow "NG" label with the red "LPG" label.
15)Carefully pull out the control box.
Note: The control box is held in place by velcro.
16)Remove the control box cover by undoing the 3 screws. Maneuver through antenna.
18)Stick the conversion label "This unit has been converted to LPG" on the control box cover.
19)Reverse steps 16, 15 & 12.
20)Open the bottom door and remove the front panel by undoing the 6 screws.
Regency FG39 FireGenie Freestanding Gas Stove | 17 |