Regency FG39-NG, FG39-LPG Louver Installation, Flueing Introduction, Installation Precautions

Models: FG39-NG FG39-LPG

1 36
Download 36 pages 8.73 Kb
Page 7
Image 7
LOUVER

INSTALLATION

LOUVER

INSTALLATION

1)Attach the top & bottom louvres to the side stove panel using 2 screws per side.

FLUEING

INTRODUCTION

The DV Stove Horizontal Flue Kit and the Simp- son Dura-Flue Room Sealed System Model DV- GS fluing systems, in combination with the Regency Room Sealed Freestanding Gas Stove, FG39-NG, and FG39-LPG, have been tested and listed as direct flue heater systems by AGA.

These units use the "balanced flue" technology Co-Axial system. The inner liner flues products of combustion to the outside while the outer pipe draws outside combustion air into the combustion chamber thereby eliminating the need to use heated room air for combustion and losing warm room air up the chimney.

Note: These flue pipes must not be con- nected to any other appliance.

The gas appliance and flue system must be flueed directly to the outside of the building, and never be attached to a chimney serving a separate solid fuel or gas burning appliance. Each direct flue gas appliance must use it's own separate flue system. Common flue systems are prohibited.

IMPORTANT

Read all instructions carefully before starting the installation. Failure to follow these instruc- tions may create a fire or other safety hazard, and will void the warranty. Be sure to check the fluing and clearance to combustible require- ments. Consult your local building codes before beginning installation.

The location of the termination cap must con- form to the requirements in the Exterior Flue Termination Locations diagram on page 8.

INSTALLATION

PRECAUTIONS

These fluing systems are engineered products that have been designed and tested for use with the FG39-NG, and FG39-LPG. The war- ranty will be voided and serious fire, health or other safety hazards may result from any of the following actions:

1)Installation of any damaged Room Sealed component

2)Unauthorized modification of the Room Sealed System

3)Installation of any component part not man- ufactured or approved by Simpson Dura- Flue or FPI Fireplace Products International Ltd.

4)Installation other than as instructed by Simpson Dura-Flue and FPI Fireplace Prod- ucts International Ltd.

Warning: Always maintain required clearances (air spaces) to nearby combustibles to prevent a fire haz- ard. Do not fill air spaces with insu- lation.

Be sure to check the flue termination clearance requirements from decks, windows, soffits, gas regulators, air supply inlets and public walkways as specified in the Exterior Flue Terminal Locations on page 8 and in your local building codes.

The gas appliance and flue system must be flueed directly to the outside of the building, and never be attached to a chim- ney serving a separate solid fuel or gas- burning appliance. Each direct flue gas ap- pliance must use it's own separate flue sys- tem. Common flue systems are prohibited.

SAFETY

PRECAUTIONS FOR

THE INSTALLER

1)Wear gloves and safety glasses for protection.

2)Exercise extreme caution when us- ing ladders or on roof tops.

3)Be aware of electrical wiring loca- tions in walls and ceilings.

Regency FG39 FireGenie Freestanding Gas Stove

7

Page 7
Image 7
Regency FG39-NG Louver Installation, Flueing Introduction, Installation Precautions, Safety Precautions For The Installer