Regency FP90 Heatwave KIT not EPA Approved, General, Listings and Code, Approvals Information

HEATWAVE KIT (NOT EPA APPROVED)

LISTINGS AND CODE	GENERAL
APPROVALS	INFORMATION

3) This kit is tested and safe when installed in

accordance with this installation manual.

Please read all instructions before starting

installation and follow all instructions

This Kit has been approved for use with Models EX90 / R90. This kit has been tested in accordance with National Safety Standards, and has been certifi ed by OMNI Test Laboratories for installation and operation in Canada as described in these Installation and Operating Instructions.

Check with your local building code agency before you begin your installation to ensure compliance with local codes, including the need for "permits" and follow-up inspections. If any problems are encountered regarding code approvals, or if you wish clarifi cation on any of the instructions contained here, contact your local dealer.

The Heat Wave Air Duct Kit increases the effectiveness of your fireplace by dispersing warm air from the fireplace to remote locations in the same room or other rooms in your home.

Up to two kits may be installed on the fireplace. Please Note: Only 1 HeatWave kit may be operated at one time. This includes the internal blower option as well.

Important Installation Notes

1)The appliance installation must conform with local codes or, in the absence of local codes, with the current Canadian or National Gas Codes, CAN1-B149 or ANSI Z223.1 Installation Codes.

2)The appliance when installed, must be electrically grounded in accordance with local codes, or in the absence of local codes with the current National Electrical Code, ANSI/NFPA 70 or CSA C22.1 Canadian Electrical Code.

carefully during installation.

4) Installation of this kit must be performed by

a qualifi ed service technician.

5) The Heat Wave Kit must be installed only

as specifi ed. Any modifi cations of the kit or

components will void the warranty and may

cause a fi re hazard.

6) Plan the location of the fireplace and the

warm air duct runs, see diagram 1 as a

guide for possible duct runs and locations.

Maximum Duct Run: 20 ft. (6.1m) per

kit.

NOTE: Airfl ow through the duct system is

affected by the duct length and number of

bends. Keep the length and bends to a

minimum to maximize performance.

HEATWAVE KIT

Included with Kit:

1946-010 20 ft. (6.1 m) of 6" dia. fl ex pipe

1946-517 Fan housing assembly

1910-412 Variable wall rheostat

1946-006 Air register

1946-005 Register adaptor frame (thick)

1946-000 Round Duct collar

1946-001 Oval Duct collar

1946-002 Duct adaptor (round to oval)

1946-045 Insulation (60") Hardware package

If any parts are missing or damaged, contact your dealer before starting installation. DO NOT install a damaged kit.

PARTS

Diagram 1: Guide for possible air duct runs and locations. Keep duct length and number of

bends to a miniumum. Maximum duct length is 20 ft. (6.1m) per kit.

FPI FP90 Wood Fireplace 31