Regency P33-LP4 Installation, Standard Flush Door, Optional Flush Trim, 250, Cutout, Diagram

INSTALLATION

250

253

254

8)Pull off ember size pieces of rock wool and gently place them on the front of the burner tray in the places shown in the photo below. Do not compress the rock wool, leave it loose.

Separate platinum embers and place them on the front of the burner on and around the rock wool.

6)Place the bottom left front edge of Log 251 against the left edge of the burner tray and rest the log on the cutout on Log 253.

250

251

253 254

Cutout

7)Position Log 252 across the cutouts in Logs 254 and 253. The notch in the bottom right end fi tting against the 5th grate tab.

252

253 254

5th Grate Tab

		250
251		252
253	254

Place rock wool in these 2 locations

on the burner tray.

9)Test fi re to ensure proper light off (make sure fl ame fl ows smoothly from one end of burner to the other). If there is any fl ame hesitation, check that area for any blockage of the burner ports.

10)Install fl ush glass and bay glass (if used) as per instructions in this manual.

STANDARD FLUSH

DOOR

The standard flush door comes with a black frame. To install the frame, simply hook the top door fl ange onto the top of the unit and swing the door towards the unit, diagram 1. Be careful that the glass gasket does not roll up; there must be a gap between the gasket and the door lip to ensure that the door sits securely on the unit. See Diagram 2.

Diagram 1

Diagram 2

Use the hook to pull the spring out until you can put the hook into the slot on the bottom door bracket. Repeat for 2nd spring. See diagram 3.

Diagram 3

To remove the fl ush door, reverse the above steps.

OPTIONAL FLUSH

TRIM

Attach the round magnets to the back of the top trim piece and to the bottom trim piece, then attach trim to the top and bottom of Flush door.

32 Regency® P33-4 Zero Clearance Direct Vent Gas Fireplace