Connecting the Machine

When using in ad hoc mode / 802.11 ad hoc mode

1

1

2

ZGDH600J

1.If the IEEE 802.11b interface unit is functioning, the LED lights up in or- ange.

2.If it is connected properly to the network, the LED is green when in ad hoc mode or 802.11 ad hoc mode. If the LED is blinking, the machine is searching for devices. The LED will light after a few seconds.

Print the configuration page to verify settings.

Note

For details about printing a configuration page, see "Print I/F Settings".

Reference

p.52 “Print I/F Settings List”

Checking the Signal

This section describes how to check the machine's radio wave status.

When using in infrastructure mode, you can check the machine's radio wave status using the control panel.

ASelect [System Settings] using {U} or {T}, and then press the {OK} key.

BSelect [Interface Settings] using {U} or {T}, and then press the {OK} key.

CSelect [IEEE 802.11b] using {U} or {T}, and then press the {OK} key.

DSelect [Wireless LAN Signal] using {U} or {T}, and then press the {OK} key. The machine's radio wave status appears.

EAfter checking radio wave status, press the {OK} key.

FPress the {User Tools/Counter} key to return to the User Tools/Counter menu.

Note

For the procedure of entering the System Settings, see "Accessing User Tools".

Reference

p.4 “Accessing User Tools”

p.29 “Using Utilities to Make Network Settings”

p.51 “IEEE 802.11b”

14