Ricoh 161F, 161SPF [Outside], Reference, Push Phone, Clear/Stop, [Extension], [Push Phone], [Fax Features], [Fax Features], ❖G3 Analog Line, [G3 Analog Line]

Administrator Tools

❖Select Dial/Push Phone

Use this function to select a line type.

Dial and Push lines are available for selection. The default setting is Push Phone.

This function is not available in some areas.

A Select [Fax Features] using {U} or {T}, and then press the {OK} key.

B Select [Administrator Tools] using {U} or {T}, and then press the {OK} key.

C Select [Select Dial/Push Phone] using {U} or {T}, and then press the {OK} key.

D Select [Push Phone] or [Dial Phone (10PPS)] using {U}or {T}, and then press the {OK} key.

❖G3 Analog Line

You need to make the following settings for the G3 Analog Line before you
	4
connect the machine to a standard G3 analog line.

•When your machine is connected through a PABX, set to Extension. If it is connected directly to the telephone network, set to Outside.

•Outside Access No.

Use this setting if your machine is connected to a PABX that requires you to dial a certain number such as "0" followed by a pause to connect to the outside line. By programming "0" as the PSTN Access Number, a pause will be inserted automatically after the "0" when dialing.

ASelect [Fax Features] using {U} or {T}, and then press the {OK} key.

BSelect [Administrator Tools] using {U} or {T}, and then press the {OK} key.

CSelect [G3 Analog Line] using {U} or {T}, and then press the {OK} key.

DSelect [Extension/Outside] using {U} or {T}, and then press the {OK} key.

ESelect [Extension] or [Outside] using {U} or {T}, and then press the {OK} key.

FSelect [Outside Access No.] using {U} or {T}, and then press the {OK} key.

GEnter the Outside Access No. using the number key, and then press the {OK} key.

You can program the number up to two digits.

If you make a mistake, press the {Clear/Stop} key, and then enter again.

HPress the {User Tools/Counter} key.

Reference

p.4 “Accessing User Tools”

p.233 “Registering Names to a Group”

p.96 “Parameter Setting”

p.106 “Program Special Sender”

85