Getting Started

Setting Paper on the Bypass Tray

This section gives instructions for set-

1 ting paper on the bypass tray. Use the bypass tray to print onto OHP trans- parencies, labels, thick paper, and envelopes that cannot be loaded in the paper tray.

Reference

For details about setting paper in the regular paper tray, see General Settings Guide.

Note

❒When loading letterhead paper, pay attention to its orientation. See “Orientation-Fixed Paper or Two- Sided Paper”, General Settings Guide.

❒Paper within the following dimen- sions can be set in the bypass tray:

•Vertical: 90 - 305 mm (3.6 - 12.1 in.)

•Horizontal: 148 - 600 mm (5.9 - 23.7 in.)

❒Be sure to set the paper with the side you want to print facing down in the bypass tray.

❒When loading OHP transparencies or thick paper in the bypass tray, make the paper setting using the control panel or printer driver.

❒The number of sheets that can be loaded in the bypass tray depends on the paper type.

❒Paper sizes fed from the bypass tray are output first sheet down, print side-up.

Limitation

❒The following functions are disa- bled when printing from the by- pass tray:

•Duplex printing

•Auto Tray Select

•Auto Tray Switching

•Rotating Collate

•Staple (when the optional unit is installed)

•Punch (when the optional unit is installed)

Important

❒When printing using the printer function, original images are al- ways rotated by 180 degrees (the orientation of images to be printed is opposite to that of the copier function). When printing onto pa- per with specific orientation re- quirements, such as envelopes and letterheads, make sure to rotate the paper feed orientation to 180 de- grees.

❒Be sure to set the paper size using the printer driver when printing data from the computer. The paper size set using the printer driver has priority over the one set using the display panel.

A Open the bypass tray.

AEU004S

14