Ricoh Caplio RR30 operation manual Troubleshooting, „Shooting

Appendix

F. Troubleshooting

Refer to the symptoms and measures listed below before submiting the camera for repairs. If the problem persists, contact your nearest Ricoh Service Center.

„Power Supply

Symptom	Cause	Measure	Page
The power does not	Batteries are not loaded. Or they are	Load the batteries correctly. Recharge or use	p.9
come on.	exhausted.	the AC Adaptor.	p.10
	The AC Adaptor is not connected	Reconnect it properly.	p.10
	correctly.
The power cuts out	The camera was left unattended and	Turn the power back on.	P.11
during use.	not used, so Auto Power-Off shut it		p.97
	off.
	Batteries are running low.	Recharge the batteries, Replace the batteries	p.9
		with a new set, Or, use the AC Adaptor if	p.10
		necessary.
The power does not	Camera malfunction.	Reload batteries.	p.9
go off.		If using the AC Adaptor, reconnect it.	p.10
Cannot recharge the	Battery life.	Replace the batteries with a new set.	p.9
batteries.
Batteries run out	They are being used in extreme high	—	—
quickly.	or low temperatures.
	Many shots are being taken in dark	—	—
	places inside, requiring flash.

„Shooting

Symptom	Cause	Measure	Page
Even if I press the	Batteries are not loaded. Or they are	If using alkaline batteries, replace the batteries	p.9
button, the camera	exhausted.	with a new set.
does not shoot.		If using rechargeable batteries, recharge or
		use the AC Adaptor.
	The power is not on. Or the camera	Turn the power on and turn the Mode Dial to	p.11
	is not in Shooting Mode.	Shooting Mode.
	The shutter button is not pressed all	Press the shutter button all the way.	p.30
	the way.
	The SD Memory Card is not	Format the card.	p.94
	formatted.
	The SD Memory Card does not have	Load a new card, or delete unwanted files.	p.82
	any free space.		p.13
	End of SD Memory Card life.	Load a new SD Memory Card.	p.13
	The flash is recharging.	Wait until the flash lamp stops blinking.	p.44
Even if I press the	The SD Memory Card is "locked".	Release the "Lock (write-protection)".	p.13
button, the camera
	The SD Memory Card's contact	Wipe off with a soft, dry cloth.	—
does not shoot.	surfaces are dirty.
I cannot check shot	The image confirmation time is too	Lengthen the image confirmation time.	p.100
images.	short.

145