Ricoh FW770 manual Preset Cutting

Copying

H Just as the trailing edge of the original passes the table edge, press the {RF Select/Cut} key.

2

Important

❒To cancel copying, press the {Clear/Stop} key. The copier finishes the oper- ation in progress, and delivers the copy and the original.

❒To cancel on-going copying, for example, when you have inserted a wrong blueprint, press the {RF Select/Cut} key. The machine interrupts the opera- tion in progress, and delivers the copy and the original.

❒If you make copy without pressing the {RF Select/Cut}key, copied paper might come out with originial size + 310mm.

❒When you repeat the copy job with this function even if you select different sizes of the originals, this function helps you to make same size copy.

❒Once you set the cut length and press the {RF Select/Cut} key to enter the

repeat copy cycle, do not press the key. Otherwise, the copy job will be in- terrupted. If you want to repeat the copy job again, press the {Paper Feed} key. For details about job settings, seeD.

Preset Cutting

This function cuts roll paper to a selected length. The paper is cut to this length regardless of the original size.

Note

❒The default Preset Cut length is as follows. Metric Version: 1189mm, 841mm,

594mm, 420mm, 297mm Inch Version: 48.0", 42.0", 36.0", 24.0", 18.0", 11.0". To change of the Preset Cut length pattern, please contact your service represent- ative.

22