Operation Panel
1.Function indicators
These indicators show which setting you are currently editing, Press the Function key to cycle through them.
•The top indicator (Paper Length indi- cator) lights when the paper length is being set.
•The middle indicator (Leading Edge indicator) lights when the leading margin is being set.
•The bottom indicator (Copy Counter indicator) lights when the number of copies is being set.
2.Paper Length display
Shows the length of paper the Roll Feeder will send.
3.{Preset Cut} key
Press to scrolls through the preset paper lengths for the Roll Feeder.
4.{Cut Select} key
Turns Semi synchro Cut or Preset/Varia- ble Cut on and off.
5.Energy Saver indicator
Shows that the machine is in a state of wait (Energy Saver). Press key 9.
6.Troubleshooting indicators
⇒P.61 “Troubleshooting” for details.
7.Wait indicator
Shows that the copier is not yet ready to copy.
8.Ready (d), Set Original(R), Set Paper (K), Bypass Select (a) indica- tor.
When Ready indicator lights up, you can set paper.The Set Paper indicator on the left lights, and then Bypass Select indica- tor goes on.
9.{Clear Modes/Energy Saver} key
Cancels all of current settings. When you hold down this key for three seconds or more, the copier enters the Energy Saver mode allowing you to conserve power.
To exit Energy Saver mode, press this key again.
10.{Program} key
Allows you to recall or set a program. The program indicator(LED) lights after you store the setting.
3
