Ricoh FW770 manual Semi-synchro Cut Length Adjustment+19 Adjust the cut length

	Settings You Can Change with User Tools
•	Semi-synchro Cut Original Scanning Mode(+18): Selects whether the roll
	paper cut key must be pressed at the appropriate time when the trailing edge
	of the original passes the Semi-synchro cut mark, or whether the original
	must be inserted again after the original is scanned and the length is meas-
	ured.
	Note
	❒ 0: Pressing the roll paper cut key, 1: Inserting the original again
	❒ Default: 0
•	Semi-synchro Cut Length Adjustment(+19): Adjust the cut length in the
	semi-synchro cut mode.The setting can be changed from —25 to 25 by 1mm
		3
	steps.

Note

❒Default: 0

•Paper Length Up/Down Setting(+20): Select if the paper length is count down or up when the preset cut key is pressed.

Note

❒0: Down count, 1: Up count

❒Default: 0

•Paper Length Up/Down Speed Setting(+21) :The copier can scroll through the preset lengths forward or backward, and at different speeds. There are many sets of sizes from which to choose.

Note

❒0: 0.10 seconds, 1: 0.5 seconds, 2: 0.25 seconds, 3: 0.05 seconds, 4: 0.02 sec-

onds, 5: 0.01 seconds

❒Default: 0

•Fixed Paper Size Pattern Setting(+22): Select the fixed paper size pattern cho- sen when the “Preset Cut” key is press. For details about this setting, contact your service representative.

•Optional Paper Size Setting(+23 ~ +32): Up to 10 different paper size can be stored from 23 to 32.For details about this setting, contact your service repre- sentative.

•Auto Off Function setting(+33): This setting allows you to enable or disable the Auto Off function.

Note

❒0: Disable, 1: Enable

❒Default: 1

•Darker Image Density(+37): Sets the range of the ID density control to give finer control over darker images.

— ID level 1 to 7-Darker image density and low contrast settings —ID level 8 to 14-cannot be shifted

43