Ricoh GX100 VF manual Changing Image Confirmation Time LCD Confirm, 147

Changing Image Confirmation Time (LCD CONFIRM.)

Immediately after you press the shutter release button, the still image taken is displayed on the screen for a moment so you can check it. By default, the image confirmation time is set to 0.5 second, but this can be changed.

Available Settings

OFF (Image not displayed for confirmation) 0.5SEC. *Default setting

1SEC.

2SEC.

3SEC.

30SEC.

To change the image confirmation time, follow the steps below.

1 Display the SETUP menu.

• For the operating procedure, see P.135.

2 Press the " button to select [LCD CONFIRM.] and press the $ button.

3 Press the !" buttons to select the desired setting.

4 Press the MENU/OK button, or press the # button and then the MENU/OK button.

Caution------------------------------------------------------------------------------------------

When [LCD CONFIRM.] is set to 0.5 seconds, symbols such as the zoom bar may remain on the monitor while the image is displayed.

Note ----------------------------------------------------------------------------------------------

It is convenient to set the image confirmation time to [30SEC.] to allow enough time to view the image. This is particularly useful when using an LCD viewfinder. Even if you set the image confirmation time to [30SEC.], you can half-press the shutter release button to return to shooting mode and shoot a picture.

5

Changing Camera Settings

147