Ricoh LD215c Using the One Sheet Bypass Tray, Inserting Paper into the One Sheet Bypass Tray

Using the One Sheet Bypass Tray

Inserting Paper into the One Sheet Bypass Tray

This section gives instructions for setting paper on the One Sheet bypass tray.

For details about paper size and paper type, see “Recommended Paper Sizes and Types”, About This Machine.

Important

❒The following functions are disabled when printing from the One Sheet by- pass tray:

•Duplex printing

•Auto Tray Select

•Auto Tray Switching

•Rotating Collate

❒Use the One Sheet bypass tray to print OHP transparencies. Do not load onto other paper trays.

❒Be sure to open the One Sheet output tray. A sheet loaded on the One Sheet bypass tray is printed from the One Sheet output tray only.

❒Use the One Sheet Bypass tray to print on paper that is thicker than 163 g/m2 (max. 220 g/m2). Do not use other trays, as paper jams and other malfunc- tions will occur.

❒You cannot print or insert paper into the One Sheet Bypass tray during printing.

❒Be sure not to leave any paper on the One Sheet Bypass tray or on the One Sheet Output tray, as this will cause a malfunction. After each print job, be sure to remove any printed sheets from the One Sheet Output tray.

❒Be sure to close the One Sheet bypass tray and the One Sheet output tray after using them. If you do not close these trays, other trays cannot be used.

A Open the bypass tray.

ALZ037S

16