Ricoh Network Guide Remote Maintenance by telnet, Note, [OK], [OK], Note, # Enter, # Enter, # Enter, Important, Important, [User Name], msh> logout, D Quit telnet

Monitoring and Configuring the Printer

Remote Maintenance by telnet

Important

❒Remote Maintenance should be password-protected so that access is allowed to administrators only.

❒The password is the same as the one of Web Image Monitor admin- istrator. When the password is changed using "mshell", other passwords change also.

❒Some command cannot be set de-

4 pending on the model type.

Using telnet

Follow the procedure below to use telnet.

Important

❒Only one user at a time can log on to perform remote maintenance.

A Use the IP address or the host name of the machine to start telnet.% telnet IP_addressB Enter your user name and password.

For details about the user name and password, consult your network administrator.

Note

❒For user authentication, enter a login user name and password, and then click [OK].

❒For user code authentication, enter a user code in [User Name], and then click [OK].

C Enter a command.

D Quit telnet.msh> logout

The configuration message about saving the changes appears.

E Enter "yes" to save the changes, and then press the {# Enter} key.

If you do not want to save the changes, enter "no", and then press the {# Enter} key. To make further changes, enter "return" at the command line, and then press the {# Enter } key.

Note

❒If the message "Can not write NVRAM information" appears, the changes are not saved. Re- peat the procedure above.

❒When the changes are saved, the network interface board is reset automatically with that changes.

❒When the network interface board resets, the print job in print process will be printed. Howev- er, print jobs in queue will be canceled.

88