Ricoh R40 manual Changing Image Confirmation Time LCD Confirm

Changing Image Confirmation Time (LCD CONFIRM.)

Immediately after you press the shutter release button, the still image taken is displayed on the screen for a moment so you can check it.

By default, the image confirmation time is set to 0.5 seconds, but this can be changed.

Available Settings

OFF (Image not displayed for confirmation)

0.5SEC. *Default setting

1SEC.

2SEC.

3SEC.

To change the image confirmation time, follow the steps below.

1. Display the SETUP menu.

For the operating procedure, see P.109.

2. Press the " button to select [LCD CONFIRM.] and press the $ button.

3. Press the !" buttons to select the desired setting.

4. Press the C/Dor # button.

5. If you pressed the # button in Step 4, press also the C/D button.

This setting is used until it is changed.

Caution

When [LCD CONFIRM.] is set to 0.5 seconds, symbols such as the zoom bar may remain on the monitor while the image is displayed.

Changing Camera Settings

117