ASSEMBLY

TO OPEN THE LEG STAND

See Figures 7 - 9.

Grasp the grips on the saw table and stand it upright as shown below.

Step on the release lever and pull the grips toward you at the same time.

Once the leg stand is released from the release lever, ease the leg stand toward the floor by pushing the grips toward the floor.

With your hands on the grips, push the leg stand towards the ground until the table saw is in an open position.

NOTE: The release lever will close over the center brace locking the leg stand in an open position.

RELEASE LEVER

Fig. 7

GRIPS

Fig. 8

LEG STAND

CENTER

BRACE

RELEASE

LEVER

Fig. 9

15

Page 15
Image 15
RIDGID TS2410LS manual To Open the LEG Stand, See Figures 7, Release Lever Grips LEG Stand Center Brace