ADJUSTMENTS

TO SET THE BEVEL INDICATOR AND BEVEL STOPS AT 0˚ AND 45˚

See Figures 48 - 51.

The angle settings of the saw have been set at the factory and, unless damaged in shipping, should not require set- ting during assembly. After extensive use, it may need to be checked.

To check for squareness, 0˚ position:

Unplug the saw and remove the switch key.

Raise the blade to a 3 in. depth of cut.

Release the bevel locking lever.

Push the height/bevel adjusting handwheel to the left as far as possible.

Lock the bevel locking lever.

Place the combination square against blade. Make sure square is not touching the tip of one of the saw teeth.

If blade is square to the table:

Check bevel indicator.

If indicator is not pointing to the 0º mark on the bevel scale, loosen the indicator adjusting screw and adjust indicator.

Retighten screw.

If blade is not square to the table:

Loosen 0º stop screw until it is even with the top of the saw table using 5/32 in. hex key.

Release the bevel locking lever and position the height/ bevel adjusting handwheel until blade is 0º to the table. Lock the bevel locking lever.

Screw the 0º stop screw until the saw blade starts to move. Check again for squareness and readjust if needed.

Check bevel indicator.

If indicator is not pointing to the 0º mark on the bevel scale, loosen the indicator adjusting screw and adjust indicator.

Retighten screw.

To check for squareness, 45˚ position:

Release the bevel locking lever.

Push the height/bevel adjusting handwheel to the right as far as possible.

Lock the bevel locking lever.

Place the combination square against blade. Make sure square is not touching the tip of one of the saw teeth.

If blade is square to the table:

Check bevel indicator.

If indicator is not pointing to the 45º mark on the bevel scale, loosen the indicator adjusting screw and adjust indicator.

Retighten screws.

ON

OFF

45

30

15 0

BEVEL LOCKING

INDICATOR

LEVER

ADJUSTING SCREW

 

Fig. 48

ON

OFF

45

30

15 0

HEIGHT/BEVEL

 

ADJUSTING HANDWHEEL

Fig. 49

 

BLADE AT 0˚ POSITION

 

0˚ STOP SCREW

30

15

0

Fig. 50

36

Page 36
Image 36
RIDGID TS2410LS To SET the Bevel Indicator and Bevel Stops AT 0˚ and 45˚, See Figures 48, If blade is square to the table