Selecting Drum Set Types
Press <√Type> or <Type®>.
Each time you press one of these buttons, the drum set type will change, and the names of the drum sounds appearing on the display will change.
Note: There is one SFX set.
Adding effects to Tones
Reverberation (REV)
Reverb is a digital effect that gives the impression that you are playing in a concert hall.
1.Press the [UTILITY] button.
2.Use the <▲> and <▼> buttons to the left of the display to modify the Reverb balance.
Setting the value to “100” gives you maximum Reverb, while selecting “0” removes all Reverb from the sound. The REV parameter actually increases or decreases the Reverb Depth for the sound currently assigned to the keyboard. It works much the same way as a cathedral: the louder you sing, the more Reverb you hear. In the case of the cathedral, singing louder means that you increase the effect send level, i.e. the level of the signal (your voice) that will be processed by the acoustic environment. The overall volume of the effect (cathe- dral) itself, however, does not change.
The other parts (the Arranger and Composer parts) are also processed by the same Reverb effect. If REV were assigned to the volume of the effect itself, select- ing the Min value would also strip the accompaniment of Reverb.
Note: The
Note: You cannot adjust the Reverb Depth of the Arranger parts or the sounds played back by the Composer function.
Adding other effects — DSP effect
DSP is short for Digital Signal Processor. The DSP effect contains a variety of effects programs, one of which you can select for the song you are about to play. See “DSP effects” on page 53 for a list of all DSP effects the
1.Select <DSP…> on the Tone Select screen.
The display now jumps to a screen similar to the fol- lowing:
2.Use the buttons to the left of the display to select the Type (kind of effect), and set its Depth with the buttons to the right of the display.
Select “OFF” from the Type screen if you don’t need a DSP effect.
Note: Only one DSP effect can be used at a time.
Note: When you select Upper, Lower, or Whole and choose the Rotary Effect, you can switch the rotation speed with the button at the upper left of the display.
Chorus effect
Your
1.After pressing <DSP…> on the Tone Select screen, press <PAGE®®>.
The display now jumps to a page similar to the following:
2.Turn the Chorus on and off with the buttons to the left of the display, and select the Chorus Depth with the buttons to the right of the display.
After several seconds, the display returns to the previous screen.
Note: The
Octave Shift: changing the pitch by octaves
Octave Shift is a function that changes the pitch of a sound in octave steps. Octave Shift can be set indepen- dently for the Lower and Upper parts.
To give you an idea of the flexibility of this system, here is an example: suppose you assign the same Tone (E.Piano 1) to both the Upper and Lower keyboard section. Though you are using the same sound, it is assigned to two parts you can shift individually. Thus, by setting Octave Shift to “+1” for the Lower part, while leaving it at “0” for the Upper part, you create an overlap of the octaves immediately to the left (Lower) and right (Upper) of the split point. You could use this feature for playing intricate parts.
1.Start by selecting the Tone you need on the Tone Select screen (see page 20).
2.Select the octave (shift amount) by pressing <Octave>.
You can raise or lower the pitch by a maximum of two octaves. After a few seconds, the display will revert to the Basic screen.
Note: When you switch off the
21
