Rotel manual Restore Factory Defaults, 32 RR-1060

32RR-1060

The data transfer begins. The sending remote dis- plays SENDING DATA. The receiving remote dis- plays RECEIVING DATA. At the completion of the data transfer (which may take 4 or 5 minutes), one of the following confirmation messages appears in the display of the receiving RR-1060:

•If the data transfer is successful, the SEND OK prompt appears on the sending remote and RECEIVE OK appears on the receiving remote.

•If the data transfer is not successful, ERROR ap- pears in the LCD on the receiving remote. and the unit reverts to normal operating mode.

After 30 seconds or when any button is pressed, the remotes return to normal operation.

NOTE: Do not attempt to use the CLONE function to transfer data from any remote other than another Rotel RR-1060.

Restore Factory Defaults

You can restore the RR-1060 to the factory default configuration with a simple procedure described below. Restoring the factory configuration restores all of the preset code sets for DEVICE/INPUT buttons, clears all learned commands, restores all factory labels, restores the factory punch-thru settings, and turns the beep tone on.

1.Press the SETUP button.

2.Press the UP/DOWN cursor buttons until DE- FAULT SETTING appears in the display. Press the ENT button to confirm.

3.A confirmation message appears in the LCD. Use the UP/DOWN buttons to select either RESET YES (to restore the factory defaults) or RESET NO (to exit without making any chang- es). Press the ENT button to confirm the selec- tion.

4.In a few seconds, a RESET OK prompt in the LCD will confirm the restoring of factory de- faults.

NOTE: Smart Macros are not reset by restoring factory defaults. Use the Clearing a Smart Macro instructions to delete stored Smart Macros.