Rotel RR-1060 manual Learning Commands From Another Remote

22RR-1060

Learning Commands

From Another Remote

If you are unable to find a command set using the Programming steps, or if you need addition- al commands, you can teach the RR-1060 com- mands directly from your existing remotes. This procedure is called Learning.

Learning Commands

To teach the RR-1060 the commands from one of your other remotes, place the two remote controls end to end as shown in the illustration at the front of this manual. The IR signals sent by the other remote must be aimed at the IR emitter/sensor of the RR-1060.

1.Press the DEVICE/INPUT button where you wish to learn this component’s codes (AUD, CD, TUN, TAPE and V1–V5).

2.Press the SETUP button (the LCD displays SET- UP). Press the ENT button to confirm.

3.Press the UP/DOWN cursor buttons until SET- UP LEARNING appears in the display. Press the ENT button to confirm.

4.Press the COMMAND button that you wish to learn (Power On, CH UP/DOWN, etc.). The name of that COMMAND button appears in the display beneath the word LEARNING.

5.Press and hold the corresponding button on the original remote until the display shows “OK” indicating that the command has been learned.

If the LCD shows an ERROR message, the command was not successfully learned. Try again.

If the LCD shows a NO DATA message, no signal was received from the original re- mote. Adjust the position of the two remotes and try Step 3 again.

6.To learn additional buttons, repeat steps 4 and 5.

7.Press the SETUP button to exit the learning mode when you are finished.