Runco CL-810 manual Selecting Video Memory, Selecting an Aspect Ratio, Adjusting the Picture

Basic Operation

Selecting Video Memory

MEM1	ISF	ISF	FACT
	NIGHT	DAY

Selecting an Aspect Ratio	ANA	4X3	LBOX	VWIDE
	16X9
	CINEMA 1		2	VCINE

Adjusting the Picture

BRT CONT COL TNT

•Press MEM1 to recall custom memory settings.

•Press ISF NIGHT to recall ISF Night settings.

•Press ISF DAY to recall ISF Day settings.

NOTE: ISF settings must be calibrated and stored by a certified ISF calibrator. For more information, please go to www.imagingscience.com.

•Press FACT (Factory) to restore factory settings for the current source. An on- screen confirmation message appears. Press FACT again to confirm.

Select an aspect ratio that suits the format of the video signal. The following aspect ratios are available.

•CINEMA: The image in the Letterbox mode is enlarged to a 16x9 image and the upper and lower portions are compressed.

•ANA16X9 (Anamorphic): A 4:3 image is stretched horizontally to fit a 16:9 screen. This setting is for 16:9 DVDs and HDTV programs.

•4 X 3 (Standard 4:3): The input signal is scaled to fit a 4:3 display mode in the center of the screen.

•LBOX (Letterbox): An image in letterbox format is enlarged to fit a 16:9 full screen display; the upper and lower portions are compressed.

•VWIDE (Virtual Wide): This setting transforms a 4x3 image to a 16x9 image.

•VCINE (Virtual Cinema): A 2.35 image is stretched vertically in both directions to fill a 16:9 image.

•Press BRT (Brightness) to adjust picture brightness.

•Press CONT (Contrast) to adjust picture contrast.

•Press COL (Color) to adjust color intensity.

•Press TNT (Tint) to adjust color tones.

28 Runco CL-810 Owner’s Operating Manual