Runco CL-810 manual Basic Operation, Turning on the Power

Basic Operation

• Turn on the main power switch. The

POWER LED will light orange.

• Press the ON button on the remote

control to turn on the projector. The

POWER LED flashes orange during

LIGHT

Turning on the Power

ONOFF

the warm up period, then lights solid

green.

• “Searching….” appears on the

screen before the projector identifies

the input signal, and remains there

until a valid signal is detected.

• If an incompatible input signal exceeds

the range of the projector, a “No signal

supported” message will be displayed

on the screen. This message remains

on the screen until you change the

input signal.

• Adjust the projected image size with the

VID S-VID COMP1 COMP2

RGBHD HDMI

ZOOM and arrow buttons on the remote

control. To focus the image, use the

FOCUS and arrow buttons.

• To adjust the vertical image position,

use the LENS and arrow buttons on the

remote control.

• To adjust the projector height or

compensate for a mounting surface that

isn’t level, turn the four adjustable feet

on the bottom of the projector.

PBP ACT PIP PIP+

FOCUS ZOOM LENS PIP-

PBP ACT PIP PIP+

FOCUS ZOOM LENS PIP-

Adjusting the Zoom and Focus

Adjusting the Vertical Lens Offset

Adjusting Projector Height

Runco CL-810 Owner’s Operating Manual 27