•Tint
•Sharpness
•Gamma
•Color temperature selection (5400, 6500, 8500 or Custom)
To save image settings to a preset, select Save Settings from the Picture Adjust menu and select “Custom,“ “ISF Day” or “ISF Night.”
Restore Settings: To recall a preset, choose Restore Settings from the Picture Adjust menu and select “Custom,” “ISF Day” or “ISF Night.” Or, use the corresponding buttons on the remote control.
White Balance: To remove any trace of color from the white areas of the displayed image, set the Color Temp. to Custom. Then, choose White Balance from the ISF Calibration menu and press ENTER.
•Gain: Use the Gain controls to correct color imbalances in the bright areas of the image. A good way to do this is to use a test pattern consisting mostly of solid white areas, such as an 80 IRE “window” pattern. If the white areas contain traces of red, green or blue, decrease the Gain for that color.
•Offset: Use the Offset controls in the White Balance
Any white balance adjustments you make here are automatically
Note stored as a “Custom” color temperature. The White Balance settings for the 5400K, 6500K and 8500K color temperatures are
Blue Enable: Blue Enable removes all red and green color information from the image, simulating a blue filter. You can use it instead of a blue filter when performing color and tint adjustments.
Factory Reset: To reset all Crystal Series LCD settings to their factory defaults, select Factory Reset from the ISF Calibration menu and press ENTER. To confirm the reset, press 
or 
to highlight Yes and press ENTER again. This command is not undoable. Use it with caution!
| White Balance | ||
R Gain |
|
| 256 |
|
|
|
|
G Gain |
| 256 | |
B Gain |
| 256 | |
R Offset |
| 0 | |
G Offset |
| 0 | |
B Offset |
| 0 | |
|
|
|
|
39 |
