Runco CX-65HD, CX-OPAL47, CX-47HD Menu should be used by ISF-certified technicians only

Operation

ISF Calibration ➤ Use the ISF Calibration menu to perform advanced picture quality adjustments. This

menu should be used by ISF-certified technicians only.

ISF Calibration

Picture Adjust

White Balance

Blue Enable

Factory Reset

Splash Duration

You must enter a passcode to access the ISF Calibration menu.

Note

Picture Adjust: The controls in this menu are identical to those in the main Picture Adjust menu, but are accessible only by entering the ISF Calibration menu passcode. This makes it possible to restore the picture quality settings to what they were when the Crystal Series LCD was installed, simply by recalling the “ISF Night” or “ISF Day” preset.

•Brightness: Refer to Brightness on page 29.

•Contrast: Refer to Contrast on page 30.

•Color: Refer to Color Saturation on page 31.

•Tint: Refer to Tint on page 31.

•Sharpness: Refer to Sharpness on page 32.

•ADC Phase Adj.: This control works similarly to the Phase adjustment for RGB signals (refer to Phase on page 35). Use it to improve the apparent sharpness of 720p and lower-resolution Component, S-Video or Composite sources. For best results, adjust ADC Phase while displaying a “Sharpness” pattern (Figure 4-5).

•DNR: Refer to DNR on page 32.

•MPEG NR: Refer to MPEG NR on page 32.

•Backlight: Refer to Backlight on page 32.

•Color Temp.: To choose a color temperature setting, select Color Temp. from the Picture Adjust menu and press ENTER. (Color temperature defines the “color of gray.”) The choices are 5400K, 6500K, 8500K and Custom. The default setting, 6500K, is appropriate for most situations. Higher settings produce a “bluer” picture; lower ones impart a reddish hue to the image.

Each color temperature setting has six (6) “white balance” parameters associated with it (two each for red, green and blue). (The White Balance settings for the 5400K, 6500K and 8500K color temperatures are factory-set and cannot be changed.)

To create a “Custom” color temperature, select Custom from the Tip Color Temp. menu and press ENTER. Then, press ENTER a

second time to go directly to the White Balance menu. (This shortcut is available only from the ISF Calibration menu.)

•Gamma: Refer to Gamma on page 33.

•Save Settings: For each input and supported resolution, the Crystal Series LCD lets you save image quality settings as presets that you can recall at a later time. You can create up to three presets – designated “Custom,” “ISF Day” and “ISF Night” – per input and resolution.

You should save changes to any of the following settings to a preset; otherwise they will be lost when a new input source or resolution is selected:

•Brightness

•Contrast

•Color saturation

38 CX-47HD/CX-OPAL47/CX-65HD Installation/Operation Manual