Runco LS-10D Mounting the LS-10d, Floor Mounting Upright Ceiling Mounting Inverted, an Enclosure

Installation

3.5

Mounting the LS-10d

Floor Mounting (Upright) ➤

Ceiling Mounting ➤

(Inverted)

There are several methods for mounting the projector. Depending on your chosen installation, one method may be more suitable than another.

In typical front and rear screen installations, the projector can be mounted to a secure and level surface such as a table or cart. Carts are useful when moving a projector during a presentation or from site to site. If possible, lock the wheels when it’s in position to prevent it from being moved during a presentation.

For fixed installations, and for those that want the projector out of sight or have a limited space for projector and audience, you can invert the LS-10d and suspend it from the ceiling using a specially-designed ceiling mount fixture.

Use only the Runco-approved ceiling mount kit designed for your

Note projector.

	Install the ceiling mount kit according to the instructions provided with it.
	If you are ceiling-mounting an LS-10d with an anamorphic lens, perform these additional
	steps to secure the plate Security Hooks to the ceiling (refer to Attaching the Security
	Hooks on the previous page).
	1.	Install ceiling hooks (not supplied) into the ceiling directly above the Plate Hooks. The
		ceiling hooks should be small enough to accept a Chain End but strong enough when
		installed to each support 40 pounds or more.
	2.	Attach a Chain End to the Chain and then connect it to one of the ceiling hooks.
	3.	Cut the Chain to a length equal to or slightly greater than the distance between the
		ceiling hook and the corresponding Plate Hook.
	4.	Attach a Chain End to the other end of the Chain. Then, use the Chain to connect the
		ceiling hook and the Plate Hook.
	5.	Repeat Steps 2 through 4 for the other ceilling hook/Plate Hook pair.
Installing the Projector in ➤	The projector can also be inverted and placed in an enclosure above and behind the
an Enclosure	viewing area. Install four feet on the inside bottom surface of the enclosure on which the

projector can rest. A variety of materials can be used for this purpose (for example, rubber crutch tips or turntable feet).

28 Runco LS-10d Installation/Operation Manual