Runco LS-10D Connecting 12-volt Trigger Outputs to External Equipment, mm mini plug

Installation

DHD Controller: Connect retractable screens, screen masks or other 12-volt trigger-activated equipment to the 12-volt trigger outputs on the DHD Controller; see Figure 3-14.

Connecting 12-volt

Trigger Outputs to

External Equipment

Retractable Screen or other 12-volt trigger-activated device

Sleeve = Ground

Tip = +12V

	TRIGGERS		USB
	1	2	3
Component / SCART			HDMI 1
Y	Video 1	Video 2

HD1

HD2

Pb	Pr	Video 3
			HDMI 2

RS-232

To Accesso HDMI 3

HDMI 4

Figure 3-14. 12-volt Trigger Output Connection from DHD Controller

Projector: If your LS-10d is equipped with an anamorphic lens, connect the lens transport to the TRIGGER 1 output on the LS-10d; see Figure 3-15.

The DHD Controller automatically activates this trigger whenever the Cinema or Virtual Cinema aspect ration is chosen.

+12V Trigger Input

3.5-mm mini plug

Figure 3-15. 12-volt Trigger Output Connection from Projector to Lens Transport

You can also use a 12-volt trigger output on the DHD Controller to

Note control the lens transport; however, you must manually configure it for this purpose. Refer to Configure Lens Motor Trigger on DHD Controller (Optional) on page 43 for more information.

Runco LS-10d Installation/Operation Manual 37