Runco LS-10D Installing and Adjusting the Anamorphic Lens, Installation and, Adjustment

Installation

If you are installing an LS-10d with an anamorphic lens, proceed as follows to install and adjust the lens.

It is extremely important that the primary lens is properly

Note adjusted before you install the anamorphic lens. Ensure that the image from the primary lens is perfectly centered on the screen.

3.11 Installing and Adjusting the Anamorphic Lens

Attach the anamorphic lens to the bracket using the plastic knobs supplied with the lens.	Anamorphic Lens
See Figure 3-19.	Installation and
	Adjustment

Figure 3-19. Attaching the Anamorphic Lens to the Lens Mount

Configure Lens Motor Trigger on DHD Controller (Optional): The anamorphic lens solution for the LS-10d maintains constant image height independent of the aspect ratio, while using the full display resolution of the projector. It accomplishes this by moving the anamorphic lens in front of the primary lens when widescreen material is being viewed.

When the viewer transitions back to 16:9 or 4:3 source material, the anamorphic lens moves out of the light path.

If you are using a trigger on the DHD Controller to control the lens transport motor, proceed as follows to configure it for proper operation.

Note	You can skip this step if you connected the lens transport motor to
	the TRIGGER 1 output on the LS-10d, as shown in Figure 3-15.

1.Project a 2.35:1 aspect ratio test pattern or other image on the screen.

2.On the DHD Controller remote control or front panel, press MENU.

Runco LS-10d Installation/Operation Manual 43