Installation

5.Select Orientation, then choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match the installation method. Or, for front-projection installations, use the Auto setting to have the projector automatically determine the orientation (floor or ceiling) using an internal sensor.

If you are installing a Q-750d/CineWide or Q-750d/CineWide with AutoScope, proceed as follows to install and adjust the anamorphic lens.

It is extremely important that the primary lens is properly

Note adjusted before you install the anamorphic lens. Ensure that the image from the primary lens is perfectly centered on the screen.

The Q-750d Anamorphic lens mount kit consists of everything shown in Figure 3-20.Some components shipped with your projector may differ slightly from what is shown in these instructions. If any items are missing or damaged, please contact your Runco dealer or Runco Customer Service at (800) 23-RUNCO.

1Lens Adapter Ring and Mounting Screws (3x)

10 Anamorphic Lens

Set Screw

9Pitch Adjustment T-Nut (2x)

2 Pitch Adjustment Yoke for Lens

3 Height/Y Adjustment

T-Screw and Washer

(2x)

4 Pitch Adjustment

T-Screw and

Washer (2x)

5 Anamorphic Lens

Holder

8 Yaw/X Adjustment

Lever (2x)

6 1/4-20 Hex Bolt (2x)

and Washer (2x)

7 AutoScope Carriage Plate or Fixed CineWide Base Plate

Figure 3-20. Anamorphic Lens Mounting Assembly - Exploded View

3.10 Installing and Adjusting the CineWide Anamorphic Lens

Anamorphic Lens

Installation and

Adjustment

Q-750d Series Installation/Operation Manual

41

Page 57
Image 57
Runco Q-750D Installing and Adjusting the CineWide Anamorphic Lens, Anamorphic Lens Installation Adjustment