Operation
Information ➤
Information
Signal
System
Field Service
Manufacturing
Signal / System: Select Information from the Main Menu, then choose either Signal or System to display information about the current input signal (resolution, frequency, type et cetera) and installed firmware versions, as well as other information that uniquely identifies your DHD Controller and display device.
Should you ever need to contact Runco Technical Support, this information will help them answer your questions or resolve product performance issues.
Signal |
|
Input Source | HDMI 1 |
Signal Format | 1080p/60 |
Input Resolution | 1920x1080 |
Vertical Freq | 59.94 Hz |
Horizontal Freq | 67.500 kHz |
Pixel Clock | 148.500 MHz |
Color Space | REC709 |
Sync Type | Separate |
Memory Preset | ISF Night |
|
|
System
Model | DHD3 |
Display Name | |
Output Resolution | 1920x1080 |
Serial Number | 00000000 |
Boot Version | 3.0 |
Firmware Version | 3.4 |
Micro Version | 3.3 |
|
|
Calibration ➤
Calibration
ISF Settings
Display Color
Input Image
Input Color
Save ISF Night
Save ISF Day
Copy/Paste
Output Shift
Splash Configure
OSD Position
Field Service / Manufacturing: The Field Service and Manufacturing menus are
Use the Calibration menu to perform advanced picture quality adjustments. This menu
should be used by ISF-certified technicians only.
You must enter a passcode to access the Calibration menu.
Note
To recall the ISF Night or ISF Day settings, select “ISF Night” or “ISF Day” from the Memory Presets menu (see page 58) or use the corresponding remote control buttons.
Display Color: Use the Display Color settings to adjust the color balance at the DHD Controller output. These settings are saved independently for each input and display mode.
•Gain: Use the Gain controls to correct color imbalances in the bright areas of the image. A good way to do this is to use a test pattern consisting mostly of solid white areas, such as an 80 IRE “window” pattern. If the white areas contain traces of red (Pr), green (Y) or blue (Pr), decrease the Gain for that color.
•Offset: Use the Offset controls to correct color imbalances in the dark areas of the image. A good way to do this is to use a test pattern consisting mostly of dark gray areas, such as a 30 IRE “window” pattern. If the gray areas contain traces of red (Pr), green (Y) or blue (Pr), decrease the Offset for that color.
•Gamma: Select Gamma from the Display Color menu to choose a DLP
Used correctly, the Gamma control can improve contrast while maintaining good details for blacks and whites.
60 |
