Runco Q-750D 1.Serial Commands continued, External Control, Parameter min/max, Value Stored?

External Control

Table 6-1. Serial Commands (continued)

Command

Parameter (min/max)

Value

Stored?

Description

Sleep Timer Commands

SLEEPTMR?	NA		NA	Returns sleep timer setting
STOFF	NA		YES	Sets the sleep timer to Off
ST30MIN	NA		YES	Sets the sleep timer to 30 minutes
ST60MIN	NA		YES	Sets the sleep timer to 60 minutes
ST90MIN	NA		YES	Sets the sleep timer to 90 minutes
ST2HRS	NA		YES	Sets the sleep timer to 2 hours
ST4HRS	NA		YES	Sets the sleep timer to 4 hours
		Miscellaneous Commands
DISPLAY?	NA		NA	Returns display device input source
				value, as follows:
				1	= Auto
				43 = Q-750d
INRES?	NA		NA	Returns input resolution
MODEL?	NA		NA	Returns product model name
OUTRES?	NA		NA	Returns output resolution
SERNUM?	NA		NA	Returns DHD Controller serial number
SWVER?	NA		NA	Returns software version number
SYSSTATE?	0/4		NA	Returns current system state
				0	= Off
				1	= Initializing
				2	= On
				3	= Powering Down
				4	= Error
TRIGGER	1/3		YES	Assigns trigger to currently-selected
				aspect ratio

The following serial commands are meant to emulate buttons on the remote control or DHD Con- troller front panel. Each button has its own serial command, so effectively it is as if you were using the IR remote only you’ll be doing so via serial commands. These commands provide active OSD responses just like the IR remote.

DOWN	NA	NA	Down-Arrow ( ) key
ENTER	NA	NA	ENTER key
EXIT	NA	NA	EXIT (RETURN) key
LEFT	NA	NA	Left-Arrow ( ) key
MENU	NA	NA	MENU
RIGHT	NA	NA	Right-Arrow ( ) key
UP	NA	NA	Up-Arrow ( ) key

Q-750d Series Installation/Operation Manual 77