•Clean the compartment inside the appliance.
•Holding it by its handle, slide the brew unit back in place until it locks in place.
•Insert the dump box, the drip tray and grill back in place. Close the door (15).
•Regular lubrication of the brew unit is also recommended.
•Contact the nearest Service Center to you for more information.
11 DESCALING
Limescale / mineral / scale
We recommend the Saeco descaler. You can also use any citric based,
decalcifier for these systems.
Caution! Never use vinegar.
To descale the appliance proceed as follows:
•Mix the descaler with water as specified on the package and fill the water tank.
•Switch ON the appliance with the ON/OFF switch (7).
•Press the button (26) for at least 5 seconds to select the descaling operating mode; the LED will come on steady when descaling activated.
•Direct the steam nozzle (14) toward the drip tray.
•Position a large container under the steam nozzle and turn the hot water knob counterclockwise (16). The appliance starts an automatic descaling cycle with pauses preset by the manufacturer and managed automatically by the appliance.
•At the end of the cycle, the flow of the descaling solution is shut off and the 5 buttons start flashing simultaneously.
•Turn the knob of the hot water nozzle (16) clockwise to OFF. At this time the warning light
(27)flashes.
•Rinse the water tank and fill it with fresh water.
•Position a large container under the steam nozzle and empty 2/3 of the contents of the water tank by turning the steam knob (16)
ENGLISH
counterclockwise; to shut off the flow, turn the knob (16) clockwise.
•Let the appliance heat up and empty the remaining contents of the water tank by pressing the hot water button (25) and turning steam knob (16) counterclockwise; to stop flow, turn it clockwise.
If you use a descaling/ decalcifying product other than Saeco’s, follow the manufacturer’s directions on the
package to mix the right quantity of product/water. Then descale as described above.
If the descaling cycle is interrupted by switching the machine OFF, it will continue when the machine is switched back
ON . You must finish the descaling cycle.
12 FUNCTION PROGRAMMING
The appliance allows you to program some parameters depending on your needs.
To program the functions, you must enter the programming mode as follows:
•Ensure that the ON/OFF switch (7) of the appliance is switched to “O”/OFF and that the hot water / steam knob (16) is OFF.
•Press the buttons (23) and (25) and, at the same time, switch ON the appliance using the ON/OFF switch (7).
You are now in the programming mode.
To quit the programming mode and implement your changes, switch the machine OFF and, then, back ON again using the main switch (7).
12.1 Programming water hardness
Water hardness varies, depending on the area and type of water used. This coffee maker can be adjusted so that it will work optimally with the water hardness level, expressed on a scale from 1 to 4, of your area.
The appliance is already set to an average value (hardness 3).
